Marlin Gcode M115 - Display Firmware Version Info; P.I.D. Bed Calibration Guide; Printer Homing Types | Home Positions Explained | Min/Max/ABL Probes; Sensors and Gantry Grounding; SKR E3 Mini, SKR E3 Turbo, Creality V4.2.2, and V4.2.7 LCD EMI Issue Z Axis Troubleshooting; Zits or Blobs On My Prints; Upgrade Guides. Creality 32 Bit The biggest problem is this: I'm not even able to setup the printer because the Z-axis will not auto home properly. When asked to auto home, the bed will drop slightly, and the X and Y axes will go to their home positions and then to the center of the bed. All OK so far, but when it's time to home the Z axis, the BLTouch probe will extend and Board: btt skr mini e3 v2.0 firmware: Marlin 2.0.9.2. I have a bltouch replacing the z endstop. i can move the z axis up and down and the z axis moves up when homing but does not move down. bltouch deploys and the printer just waits and then cancels homing saying "STOPPED." Unlikely but maybe. You could try superglueing them down lol. Press the auto home button. Click move and move the z axis to 0. Go to the z axis offset and put in your value. I think mine was -1.50. Save the configuration. Print stuff. My main problem is that in my guide that I follow I haven't even made it to the step where I adjust z offset. Dual Z axis will move together, but will not home together October 03, 2022 07:24PM posted what I used to make both z motors actually work on homing command in pronterface instead of just the left side running and right motor doing nothing. Have changed no pin physical connection point, so a pin connection did not correct the single motor I expect the motor to stop, when the endstop is triggered while homing. Actual behavior. The motor does not stop moving, when endstop is triggered. Steps to Reproduce. Home any axis (X, Y or Z) Version of Marlin Firmware. Marlin 2.0.7.2. Printer model. No response. Electronics. RAMPS 1.6+, TMC2130 drivers. Add-ons. Mechanical Endstop. Your .

marlin z axis not homing